Husqvarna TR 650 STRADA 2013, Workshop Manual

Page: 204 / 301

L.6
TR 650 TERRA 2013 - TR 650 STRADA 2013
H11847
H11848
H11849
1
3
2
H11850
4
5
H11851
4
5
6
2
3
BRAKES
Workshop Manual Ed. 09-2012
Brake disc
Checking the brake disc is an important safety procedure; the disc must be spot-
less, i.e. free from corrosion, oil or other dirt or deep scoring.
Front brake disc diameter: mm 300 (11.81 in.).
Front brake disc thickness (when new): mm 5 (0.196 in.).
Minimum disc thickness (wear limit): mm 4,5 (0.177 in.).
Rear brake disc diameter: mm 240 (9.45 in.).
Rear brake disc thickness (when new): mm 5 (0.196 in.).
Minimum disc thickness (wear limit): mm 4,5 (0.177 in.).
The distortion of the discs must not exceed 0.15 mm (0.006 in.) (the measurement
should be made with a feeler gauge and a disc installed on the rim).
To remove the disc from the wheel rim, you need to loosen the five retaining
screws. On assembly, clean all mating surfaces thoroughly and tighten the screws
to the specified torque.
During the removal/replacement of the discs, replace the retaining
screws!
Removing the rear brake system (Versions without ABS)
Remove the rear chassis, complete with fuel tank, and the rear wheel as described
in the relative paragraphs.
- Release the safety clip (1) and disconnect the master cylinder (2) from the
lever (3).
- Loosen the screw (4) and remove the oil reservoir (5).
- Undo the screws (6) and detach the master cylinder (2).