H.41
Part. N. 8000 A4640 (04-2005)
RIMONTAGGIO MOTORE
ENGINE REASSEMBLY
RÉCOMPOSITION MOTEUR
WIEDERZUSAMMENBAU DES MOTORS
REENSEMBLAJE MOTOR
BOZZA-DRAFT
INSTRUCTIONS FOR ASSEMBLY AND LUBRICATION
Instructions for assembly
COMPONENT
PROCEDURE
- Flywheel - crankshaft cone
Degrease with solvent
- Crank mechanism
Mount with engine oil
- Crankshaft - Engine crankcase
Insert the crankshaft into the bearings
- Cylinder head cover-Cylinder head
“Loctite 510” liquid gasket (Pianermetic)
- Rocker arms-Cylinder head cover
Fit the shim for an axial play of 0.1÷0.3 mm
- Crankcase surfaces
Glue the two half-carnkcase with “Loctite 510” liquid gasket (Pianermetic)
- Spring for gearshift
Fit it with the opening towards the engine center
- Piston rings
See page H.25
- Intake manifold-Cylinder head
Fit using “RHODORSEAL” seal
- Clutch control lever
See page D.23
Instructions for lubrication
LUBRICATING POINTS
LUBRICANT
- Roller bearing - Connecting rod small end pin
Engine oil
- Piston - Cylinder liner
Spray with Engine oil
- Intake and exhaust valve
Engine oil
- Timing shaft cam
Engine oil
- Rocker arm pivots
Engine oil
- Stud bolts-Nuts
Engine oil
- Cylinder head nuts
Grease
- Clutch disc housing bush
Engine oil
- Gears-Shafts
Engine oil
- "O" Rings
Grease
- Clutch control pin
Engine oil
- Steel on steel couplings inside the gearbox
Engine oil
- Seal rings
Grease
- Clutch control shaft
Engine oil
- Piston pin-Connecting rod small end
Engine oil
