Husqvarna TC 50, Owner'S Manual

Page: 54 / 137

11 SERVICE WORK ON THE CHASSIS
52
–
Check the steering head bearing and replace if
required.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 43)
11.12 Adjusting the steering head bearing play
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 43)
H01859-12
Main work
(TC 50)
–
Pull fuel tank breather
1
out of the steering stem.
–
Loosen screws
2
.
–
Loosen screw
3
.
–
Loosen and retighten nut
4
.
Guideline
Nut, steering
head M20x1.5 10 Nm (7.4 lbf ft)
Nut, steering
head M20x1.5 9 Nm (6.6 lbf ft)
Only applies when
using:
Holding wrench for
steering head bearing
(45229050000)
–
Using a plastic hammer, tap lightly on the upper triple
clamp to avoid stresses.
–
Tighten screw
3
.
Guideline
Screw, top triple
clamp M8 20 Nm (14.8 lbf ft)
–
Tighten screws
2
.
Guideline
Screw, top triple
clamp M8 20 Nm (14.8 lbf ft)
–
Position the fuel tank breather
1
in the steering stem.
A00097-10
(TC 50 Mini)
–
Pull fuel tank breather 1 out of the steering stem.
–
Loosen screws
2
.
–
Loosen screw
3
.
–
Loosen and retighten nut
4
.