Husqvarna TC 50, Owner'S Manual

Page: 115 / 137

17 CLEANING, CARE
113
17.1 Cleaning the motorcycle
Note
Material damage Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
–
Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
–
Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance
60 cm (23.6 in)
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
401061-01
–
Close off the exhaust system to keep water from entering.
–
Remove loose dirt first with a soft jet of water.
–
Spray dirty parts with a normal commercial engine cleaner
and then brush off with a soft brush.
Info
Use warm water containing normal motorcycle cleaner
and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle;
always rinse the vehicle with water first.
–
After rinsing the motorcycle with a gentle spray of water,
allow it to dry thoroughly.
–
Remove the closure of the exhaust system.
–
Empty the carburetor float chamber.
Warning
Danger of accidents
Moisture and dirt impair the
brake system.
–
Explain to your child that he or she must brake
carefully several times to dry out and remove dirt
from the brake linings and the brake discs.
–
After cleaning, let your child ride the vehicle a short distance
until the engine warms up and the brakes have dried due to
careful application of the brakes.
Info
The heat produced causes water at inaccessible loca-
tions in the engine and on the brake system to evapo-
rate.