Husqvarna TC 125, Owner'S Manual

Page: 84 / 163

11 SERVICE WORK ON THE CHASSIS
82
M01368-01
–
Check that the chain guide is firmly seated.
» If the chain guide is loose:
–
Tighten the fitting on the chain guide.
Guideline
Remaining
screws, chassis M6 10 Nm (7.4 lbf ft)
Remaining nuts,
chassis M6 10 Nm (7.4 lbf ft)
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 53)
11.40 Checking the frame
M01314-01
–
Check the frame for cracks and deformation.
» If the frame exhibits cracks or deformation due to a
mechanical impact:
–
Change the frame.
Info
Always replace a frame that has been
damaged due to a mechanical impact. Repair
of the frame is not authorized by Husqvarna
Motorcycles.
11.41 Checking the swingarm
401520-01
–
Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or
deformation:
–
Change the swingarm.
Info
Always change a damaged swingarm. Repair
of the swingarm is not authorized by Husq-
varna Motorcycles.
11.42 Checking the throttle cable routing
Preparatory work
(TC 250)
–
Turn the tap handle of the fuel tap to the OFF position.
(TX 300)
–
Turn the tap handle of the fuel tap to the OFF position.
–
Remove the air filter box cover. ( p. 68)
–
Remove the seat. ( p. 66)
–
Remove the right side cover. ( p. 73)
–
Remove the fuel tank. ( p. 75)