Husqvarna T540i XP, Operator'S Manual, Page: 20 / 32

2. Hold the product tight. Put your hands around the
handles.
3. Apply full power and tilt your left wrist forward to
engage the chain brake.
4. Make sure that the saw chain stops directly.
WARNING:
Do not let go of the front
handle!
To do a check of the power trigger lockout
1. Make sure that the power trigger and power trigger
lockout move freely and that the return spring
operates correctly.
2. Push the power trigger lockout forward (A) and
down (B). Hold the power trigger lockout against
the handle and make sure that it goes back to its
initial position when you release it.
B
A
3. Make sure that the power trigger is locked at the
idle position when the power trigger lockout is
released.
4. Start the product and apply full power.
5. Release the power trigger and make sure that the
saw chain stops and stays stationary.
WARNING:
If the saw chain
rotates when the power trigger is in the
idle position, speak to your servicing
dealer.
To do a check of the chain catcher
1. Make sure that there is no damage on the chain
catcher.
2. Make sure that the chain catcher is stable and
attached to the body of the product.
To do a check of the functions of the user
interface
1. Start the product. Refer to To start the product on
page 15 .
2. Push and hold the start/stop button.
20 1036 - 005 - 29.06.2020