Husqvarna T 10000, Operator'S Manual, Page: 9 / 68

B
A
180°
To monitor the filter conditions
The product has a manometer to monitor the filter
conditions. The manometer shows the total load of the
product in 3 levels, (A) maximum vacuum level (0m/s),
(B) filter cleaning level and (C) level without load.
A
B
C
1. Clean the prefilter if the manometer is above the
filter cleaning level (B). Refer to To clean the pre
filter on page 10
.
2. Replace the Hepa filter filter if the suction continues
to be not sufficient. Refer to
To change the Hepa
filter on page 11 .
Maintenance
Introduction
WARNING:
Use personal safety
equipment, refer to
Personal protective
equipment on page 7 , during service. Dust
can be exposed during maintenance and
service.
WARNING:
Most accidents involving
machines occur during trouble shooting,
service and maintenance as staff have to
locate themselves within the risk area of the
machine. Prevent accidents by being alert
and by planning and preparing the work.
WARNING:
The motor should be
switched off during operations described in
this chapter unless otherwise stated.
WARNING:
All checks involving electric
components should only be performed by a
licensed electrician.
877 - 006 - 03.02.2022 9