Husqvarna SMR 450-510/2008-I.E., Owner'S Manual, Page: 126 / 530

24
ENGINE START (TE-SMR)
With cold engine, as after a prolonged inactivity of the motor-
cycle or in presence of a low external temperature, proceed as
follows:
1) set ignition key (1) in IGNITION position (the buzz that you
hear when you turn the key to IGNITION is caused by the
fuel pump which puts the feeding system under pressure);
2) pull the starter lever (2);
3) pull the clutch lever (3);
4) shift gear pedal (4) in neutral position then release the
clutch control lever;
5) press the engine start-stop switch (5) then the start button
(6).
Put the start lever (2) in its initial position as soon as the en-
gine is idling. When starting with an already warmed up en-
gine DO NOT USE the starter. When a cold engine has just been
started, do not increase revs, to ensure an
adequate oil warm-up and circulation.
NOTE
A safety switch is set on the clutch lever support. This switch al-
lows you ONLY to start the engine with idle gearbox, or with
the gear engaged and the clutch lever pulled.
IMPORTANT
NEVER START WITH DISCONNECTED BATTERY.
TE-SMR TE-SMR
TE-SMR
4
2
3
5
6
1
Cap5_GB 9-07-2007 16:25 Pagina 24