Husqvarna RA-V, Operator'S Manual

Page: 7 / 32

• Around stones and trees.
• Near water.
CAUTION: Do not put the gear housing
in water.
Assembly
To install the cutting unit
Note: The cutting attachment must only be installed to a
grass trimmer. Refer to
Intended use on page 2
.
WARNING: Use protective gloves when you
hold the blades.
1. Remove the clamp screw from the gear housing.
2. Put the shaft (B) into the gear housing (A). Make
sure that the drive shaft engages in the gear
housing.
B
A
CAUTION: Make sure that the holes are
aligned. If the holes are not aligned, the
gear housing can be damaged.
3. Install the clamp (C) and tighten the lock screw (D).
Install the clamp screw (E) for the gear housing and
tighten it.
E
D
C
1051 - 001 - 18.04.2019 7