1. Remove the 2 screws that hold the belt shield and lift
it off.
2. Lubricate with a grease gun through the nipple at the
right side, below the lower belt pulley. Lubricate until
grease is pushed out of the rear side of the nipple.
3. Attach the belt shield and tighten the 2 screws.
Troubleshooting
Troubleshooting schedule
If you cannot find a solution to your problems in this
owner's manual, speak to your Husqvarna service
agent.
Problem
Cause
The starter motor does not turn
the engine over
The parking brake is not applied. See
To apply and release the parking brake on
page 93
.
The lift lever for the cutting deck is in mow position. See
.
To replace the main fuse on page 98
.
The ignition lock is defective.
The connection between the cable and the battery is bad. See
page 87
.
The battery is too weak. See
To charge the battery on page 98
.
The starter motor is defective.
The engine does not start when
the start motor turns the engine
over
There is no fuel in the fuel tank. See
.
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
The engine does not run
smoothly
The spark plug is defective.
The carburettor is incorrectly set.
The air filter is clogged. See
To clean and change the air filter on page 97
.
The fuel tank vent is blocked.
There is dirt in the carburetor or fuel line.
104
844 - 002 -
