Husqvarna NUDA 900 2012, Workshop Manual, Page: 134 / 363

F1.20
NUDA 900 2012/2013 - NUDA 900 R 2012/2013
H10268
8
7
9
10
11
H10269
6
7
12
H10270
1
2
3
4
H10271
1
GENERAL ENGINE PROCEDURES
Workshop Manual Ed. 11-2011
Installation:
- Clean all components prior to installation and lubricate them with engine oil.
- Insert the pin (9) in the shaft.
- Place the rotating piston (7) on the shaft with the mark (10) facing outwards,
paying attention to the correct positioning of the pin (9).
- Fit the rotor (8) with the mark (11) facing outwards, so that it coincides with
the mark (10) on the rotating piston (7).
- Clean the sealing surfaces.
- Fit the cover (6), paying attention to the centring pin (12).
- Tighten the screws (5) to torque.
- Check the drive pin (1) for wear and replace it if it is ruined.
- Insert the drive pin (1) in the shaft.
- Fit the gear (2), making sure it engages on the drive pin.
- Fit the washer (3).
- Fit the new retaining ring (4).
- Refit the clutch as described in the relevant paragraph.
Oil pump shaft disassembly
- Remove the force pump and the oil suction pump as described in the relevant
paragraphs.
- Drain the oil as described in the relevant paragraph.
- Disassemble the oil pump shaft (1), check the shaft (1) and oil seals for wear
and replace them if necessary.
- Refit everything proceeding in reverse order as described in the relevant
paragraph.