Husqvarna NUDA 900 2012, Workshop Manual, Page: 124 / 363

F1.10
NUDA 900 2012/2013 - NUDA 900 R 2012/2013
H10234
1
2
H10235
1
2
H10446
1
2
3
4
6
7
GENERAL ENGINE PROCEDURES
Workshop Manual Ed. 11-2011
Starter motor idle gear removal/installation
- Remove gears (1) and (2) and check the state of wear, refit them exactly in
the correct position, making sure that a space washer is fit above the idler
gear (1).
Installation of the flywheel with freewheel control gear
- Clean the collar and internal bearing of the freewheel gear (1) and lubricate
with engine oil.
- Fit the freewheel gear (1) into the crankshaft.
- Clean the cone of the crankshaft and of the flywheel.
- Apply a thin layer of Loctite 648 on the crankshaft cone.
Pay attention that the freewheel bearing does not come into contact
with the Loctite.
- Fit the flywheel (2) onto the crankshaft, making sure that the groove and the
key (6) are aligned and that the freewheel is set on the relevant gear (1).
- Clean both crankshaft and flywheel (2) retaining screw threading.
- Tighten the screw (4) to torque with the washer (3), carefully applying a thin
layer of Loctite 648 on the screw thread.
- Refit the right crankcase as indicated in the relevant paragraph.