Operation
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the engine manual that is supplied by the
engine manufacturer.
• Do the daily maintenance. Refer to
schedule on page 9
.
To start the product
1. Set the throttle control in the start position.
2. Pull the starter rope handle slowly until you feel
resistance.
3. Release the starter rope handle to let the starter
rope go back.
4. Pull the starter rope handle until the engine starts.
5. Let the engine operate at idle speed for 2–3 minutes
before you apply full throttle.
To do if the engine does not start
If the engine does not start and white smoke shows, do
the procedure that follows.
1. Set the throttle control to the stop position.
2. Slowly pull and release the starter rope handle 5
times.
3. Do the start procedure again.
To operate the product
1. Set the throttle control in the operation position.
2. Hold the handle and move the product in the
necessary direction.
CAUTION: Do not push the product
down. Too much pressure can cause
unsatisfactory result.
3. Make sure that the rammer shoe is parallel to the
ground during the operation.
To stop the product
1. Set the throttle control in the idle speed position. Let
the engine operate at idle speed for 2–3 minutes.
8
1167 - 003 - 09.03.2020
