vibration damping units are correctly
installed and not damaged.
WARNING: Do not walk or stay below or
near a lifted product.
To safety the product to a transportation
vehicle with tie-down straps
1. Set the throttle control in the stop position.
2. Tilt the product forward until the wheels on the
handle are on the ground.
3. Attach a strap to the lifting eye and to the vehicle.
4. Attach a strap to the lift handle and to the vehicle.
Storage
• Remove all fuel from the fuel tank before you put the
product in storage for a long period of time. Discard
the fuel at an applicable disposal location.
• Clean the product before storage. Remove clay and
sand from the rammer shoe. Remove oil and dust
from the rubber parts.
• Apply a thin layer of oil on the rammer shoe to
prevent corrosion.
• Clean the air filter before storage.
• Carefully pull the starter rope handle until there is a
small resistance.
• Put a protective cover on the product.
• Keep the product in a dry and frost free area.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
Disposal
• Obey the local recycling requirements and applicable
regulations.
• Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
• When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
Technical data
Rammer shoe width 280 mm/11 in.
Rammer shoe width 330 mm/13 in.
Weight (uncrated, incl. oil, empty
tanks) kg/lb
96/212
97/214
Operation weight (EN500, incl. oil, ½
fuel), kg/lb
98/216
99/218
Engine brand / Type
Hatz / 1B20R
Hatz / 1B20R
1167 - 003 - 09.03.2020
13
