location only, in the temperature range -25–
70°C/-13–158°F.
The desktop charger operates in the voltage range 100–
240 V. The desktop charger has an adapter that can be
used in most power sockets.
The time to fully charge the battery is 2.5 hours at
correct temperature. The battery does not become
damaged if it stays in the desktop charger when fully
charged.
1. Clean the contact surfaces of the battery and the
desktop charger.
2. Connect the desktop charger to a power socket. A
yellow LED on the desktop charger shows that it is
prepared to charge.
3. Put the battery into the desktop charger. After 10
seconds, the desktop charger starts to charge.
LED indicator
Cause
Yellow.
Charger prepared.
Orange.
The battery charges.
Flashes green and yellow. The battery is almost fully
charged.
Green.
Trickle charging. Fully
charged.
Flashes orange and
green.
Error.
To install and remove a remote control battery
1. Clean the contact surfaces of the battery and the
battery slot in the remote control.
2. Put a battery (A) into the remote control.
B
A
3. Turn the lock (B) to the locked position.
4. To remove the battery, turn the lock (B) to the open
position.
To do a pairing operation between the remote
control and the product
The first time the remote control is used together with
the product, a pairing operation is necessary.
A pairing operation is also necessary if the remote
control is replaced or if you change remote controls
between products.
1. Open the rear cover of the product.
2. Put the lever for the battery switch in the battery
switch (A).
A
Note: The lever for the battery switch hangs on a
chain behind the rear cover.
3. Turn the battery switch to the locked position to
engage the battery.
4. Push the button on the receiver to start the pairing
operation. The RX indicator (A) on the receiver starts
to flash in green and yellow.
A
14
1177 - 001 - 02.04.2020
