Operation
20
www.usa.husqvarna.com
Curb-hop feature
1 Stop the engine. Never adjust the wheels while the
engine is running.
2 Disconnect the spark plug wire from the spark
plug.
3 Set the entire unit on the curb level. Loosen the
front wheel knob (A). See Figure 21.
4 Slide the front wheel (B)
all the way to the right
and tighten the front wheel knob.
5 Use the curb height adjust lever (C) to lower the
front wheel. Lower the front wheel until the front
wheel is level with the left rear wheel.
6 Position the unit so that both the right rear wheel
(D)
and the front wheel
are off to the side of the
curb and the left rear wheel
is on the curb as
shown in Figure 21.
7 Loosen the rear wheel knob (E) to lower the right
rear wheel to the pavement. Tighten the rear wheel
knob.
8 Use the curb height adjust lever
to lower the front
wheel
to the setting where the front wheel
touches
the pavement and the unit is level.
9 Connect the spark plug wire to the spark plug.
Rotating parts can contact or entangle
hands, feet, hair, clothing, or
accessories.
Traumatic amputation or severe
laceration can result.
•
Never adjust the wheels or the blade while the
engine is running.
•
Before you adjust the wheels or change the
blade position, disconnect the spark plug wire
and keep it away from the spark plug.
•
While the engine is running, never leave the
unit unattended.
•
Keep bystanders away from machine.
WARNING
Figure 21: Curb-Hopping Feature
E
C
B
A
D
