MAINTENANCE
English
–
17
General
Cleaning
Cooling system
The machine is equipped with an efficient fan to cool the
motor. Cooling air which is drawn in through the grille by
the machines rear handle passes over the stator and rotor
and out through the front of the motor housing.
In order for the machine to always be cooled sufficiently
the cooling air openings must be kept clear and clean.
Blow down the machine regularly with compressed air.
K 3000
K 3000 Wet
The machine can withstand taking in damp air and
splashes during the cutting process. Clean water does
not affect the machine’s function.
When cutting materials such as concrete or brick, which
can contain salt, you must rinse the machine after the
work is finished. The cleaning reduces the risk for
accretions building up inside the engine, which can cause
leakage current between electric components, which in
turn can cause the ground fault circuit interrupter to turn
off without intention.
•
Clean the machine daily by rinsing it with clean water
after the work is finished.
•
Place the machine with the rear handle facing
upwards. Rinse the air intakes at the rear handle with
clean water. The water will run out through the front air
outlets.
•
Connect the plug and run the engine dry for approx.
30 sec in order to speed up the drying of the engine.
Electrical Feed
Check that the cord and extension cord are intact and in
good condition. Never use the machine if the cord is
damaged, hand it in to an authorized service workshop for
repair.
!
WARNING! Inspection and/or
maintenance should be carried out with
the motor switched off and the plug
disconnected.
!
WARNING! K 3000 is not equipped with
ground fault circuit interrupter. Do not
wash the machine with water, as water
can enter the electrical system or the
engine and cause damage to the
machine or short circuit.
!
WARNING! Do not use a high pressure
washer when rinsing the inside of the
machine.
!
WARNING! Never use damaged cables.
They can cause serious, even fatal,
personal injuries.
Summary of Contents for K 3000 Cut-n-Break
Page 22: ... z UBG 5R z UBG 5R ...
Page 23: ......
Page 24: ...1153343 95 z UBG 5R z UBG 5R 2009 12 29 Original instructions ...
