Husqvarna FS 600 E, Operator'S Manual

Page: 16 / 452

CAUTION:
Do not lower the cutting
blade too quickly. If the cutting blade
hits the surface with force, it can cause
damage to the cutting blade.
2. Loosen the screw (A).
B
A
3. Rotate the indicator plate until the the position "0" is
at the center of the arrow (B).
4. Tighten the screw (A).
CAUTION:
Always do a check that
the cutting depth is correct. The indicator
helps you to get the correct cutting depth
but only gives an indication of the depth
value.
To align the pointer with the cutting
blade
Note:
The pointer must be aligned with the cutting
blade.
1. Put the inner flange along a line.
2. Lower the pointer and align the product with the
marks.
3. Align the pointer with the line.
4. If necessary, adjust the pointer until it is aligned with
the line.
Basic working techniques
WARNING:
The blade shaft rotates
when the motor is started.
• Make sure that you always can push the machine
stop button during the operation.
• Make sure that no tools or other objects have been
left on the product.
• Maintain control of the product when the motor is
started.
• Make sure that the blade guard is attached correctly
before you start the product. Do not cut without the
blade guard.
• Make line marks for all cuts before you start the
operation. Make sure that there is no risk for the
operator or the product.
• Do not turn, rotate or move the product from side to
side while the cutting blade rotates.
• Make sure that there is always 1 more person near if
you use the product. If an accident occurs, you can
get help from that person.
• Do not go away from the product without the parking
brakes engaged.
16 1620 - 004 -