Husqvarna FE 450, Owner'S Manual

Page: 101 / 128

17 TUNING THE ENGINE
99
17.4 Changing the mapping
Warning
Voiding of the government approval for road use and the insurance coverage If the combination switch is installed,
the vehicle's approval for road use is invalidated.
–
Only operate the vehicle in closed-off areas remote from public road traffic if the combination switch is installed.
Info
The desired engine characteristic can be activated via the MAP button on the combination switch.
The setting most recently selected is activated again when restarting.
The traction control can also be activated in each mapping using the
TC
button.
The mapping can also be changed during the ride.
H01180-10
Activating STANDARD mapping:
–
Press button MAP until LED 1 lights up.
Guideline
Engine speed < 4,000 rpm
STANDARD
–
balanced response
H01180-11
Activating ADVANCED mapping:
–
Press button MAP until LED 2 lights up.
Guideline
Engine speed < 4,000 rpm
ADVANCED
–
direct response
17.5 Adjusting the idle speed
Warning
Danger of accidents
The engine may go out spontaneously if the idle speed is set too low.
–
Set the idle speed to the specified value. (Your authorized Husqvarna Motorcycles workshop will be glad to help.)
F00448-10
–
Run the engine until warm.
The cold start button is deactivated
–
The cold start button is in its basic
position. ( p. 17)
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when running the
engine.
–
Use an effective exhaust extraction system when starting or running
the engine in an enclosed space.
–
Set the idle speed by turning idle speed adjusting screw

.
Guideline
Idle speed 1,800… 1,900 rpm
Tachometer (45129075000)