10 SERVICE SCHEDULE
42
10.1
Additional information
Any further work that results from the required work or from the recommended work must be ordered sepa-
rately and can be invoiced separately.
10.2
Required work
Every 45 operating hours
Every 30 operating hours/after every race
Every 15 operating hours
Once after 1 operating hour
Read out the fault memory using the Husqvarna Motorcycles diagnostics tool.
○
●
●
●
Check that the electrical system is functioning properly.
○
●
●
●
Check and charge the battery.
●
●
●
Check the front brake linings. (
●
●
●
Check the rear brake linings. (
●
●
●
Check the brake discs. (
●
●
●
Check the brake lines for damage and leakage.
●
●
●
Check the rear brake fluid level. (
●
●
●
Check the free travel of the foot brake lever. (
●
●
●
Check the frame.
●
●
●
Check the swingarm.
●
●
●
Check the swingarm bearing for play.
●
Check the heim joint for play.
●
●
●
Check the shock absorber linkage.
●
●
●
Check the tire condition. (
○
●
●
●
Check the tire air pressure. (
○
●
●
●
Check the wheel bearing for play.
●
●
●
Check the wheel hubs.
●
●
●
Check the rim run-out.
○
●
●
●
Check the spoke tension. (
○
●
●
●
Check the chain, rear sprocket, engine sprocket and chain guide. (
●
●
●
Check the chain tension. (
○
●
●
●
Grease all moving parts (e.g. side stand, hand lever, chain, ...) and check for smooth oper-
ation.
●
●
●
Check/correct the fluid level of the hydraulic clutch. (
●
●
●
Check the front brake fluid level. (
●
●
●
Check the free travel of the hand brake lever.
●
●
●
Check the play of the steering head bearing. (
○
●
●
●
Check the valve clearance.
○
●
Check the clutch.
●
Change the engine oil and oil filter and clean the oil screens.
○
●
●
●
Check all hoses (e.g. fuel, cooling, bleeder, drainage, etc.) and sleeves for cracking, leaks,
and incorrect routing.
○
●
●
●
Check the antifreeze and coolant level. (
○
●
●
●
Check the cables for damage and routing without sharp bends.
●
●
●
