Husqvarna FC 250, Owner'S Manual, Page: 75 / 149

11 SERVICE WORK ON THE CHASSIS
73
H01420-10
–
Check that the chain guide is firmly seated.
» If the chain guide is loose:
–
Tighten the screws on the chain guide.
Guideline
Remaining
screws, chassis M6 10 Nm (7.4 lbf ft)
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 46)
11.39 Checking the frame
S00867-01
–
Check the frame for cracks and deformation.
» If the frame exhibits cracks or deformation due to a
mechanical impact:
–
Change the frame.
Info
Always replace a frame that has been
damaged due to a mechanical impact. Repair
of the frame is not authorized by Husqvarna
Motorcycles.
11.40 Checking the swingarm
401520-01
–
Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or
deformation:
–
Change the swingarm.
Info
Always change a damaged swingarm. Repair
of the swingarm is not authorized by Husq-
varna Motorcycles.
11.41 Checking the throttle cable routing
Preparatory work
–
Remove the right side cover. ( p. 64)
–
Remove the air filter box cover. ( p. 60)
–
Remove the seat. ( p. 59)
–
Remove the fuel tank. ( p. 65)