Husqvarna F2203V4, Owner'S Manual

Page: 51 / 166

TUNING THE CHASSIS 11
49
11.9 Adjusting the spring preload of the shock absorber
Caution
Risk of injury
Parts of the shock absorber will move around if the shock absorber is detached incor-
rectly.
The shock absorber is filled with highly compressed nitrogen.
–
Please follow the description provided. (Your authorized Husqvarna Motorcycles workshop will be
glad to help.)
Info
Before changing the spring preload, make a note of the present setting, e.g., by measuring the spring
length.
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 54)
–
Remove the shock absorber. ( p. 63)
–
After removing the shock absorber, clean it thoroughly.
402659-10
Main work
–
Loosen screw
1
.
–
Turn adjusting ring
2
until the spring is no longer under ten-
sion.
Hook wrench (90129051000)
Info
If the spring cannot be fully released, the spring must
be removed to accurately measure the spring length.
–
Measure the total spring length while the spring is not under
tension.
–
Tension the spring by turning adjusting ring
2
to specified
dimension
A
.
Guideline
Spring preload 12 mm (0.47 in)
Info
Depending on the static sag and/or the riding sag, it
may be necessary to increase or decrease the spring
preload.
–
Tighten screw
1
.
Guideline
Screw, shock
absorber adjusting
ring M5 5 Nm (3.7 lbf ft)
Finishing work
–
Install the shock absorber. ( p. 65)
–
Remove the motorcycle from the lift stand. ( p. 54)