Husqvarna F2201U1, Owner'S Manual

Page: 119 / 163

COOLING SYSTEM 15
117
V01387-10
–
Make sure that screw
1
is tightened.
–
Position the motorcycle upright.
–
Pour coolant in up to measurement
A
above the radiator
fins.
Guideline
Dimension
A
over the radi-
ator fins
10 mm (0.39 in)
Coolant 0.95 l (1 qt.) Coolant ( p. 149)
–
Mount the radiator cap.
–
Take a short test ride.
–
Check the coolant level. ( p. 115)
15.6 Changing the coolant
Warning
Danger of scalding
During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not open the radiator, the radiator hoses or other cooling system components if the engine or
the cooling system are at operating temperature.
–
Allow the cooling system and the engine to cool down before you open the radiator, the radiator
hoses or other components of the cooling system.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
Condition
The engine is cold.
V01386-10
–
Position the motorcycle upright.
–
Place an appropriate container under the water pump cover.
–
Remove screw
1
. Take off radiator cap
2
.
–
Completely drain the coolant.