Husqvarna F2101V0, Owner'S Manual

Page: 56 / 138

11 SERVICE WORK ON THE CHASSIS
54
11.12 Adjusting steering head bearing play
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 46)
–
Remove the handlebar cushion.
Z01557-10
Main work
–
Loosen screws
1
.
–
Remove screw
2
.
–
Loosen and retighten screw
3
.
Guideline
Screw, top steering
head M20x1.5 12 Nm (8.9 lbf ft)
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
–
Tighten screws
1
.
Guideline
Screw, top triple
clamp M8 17 Nm (12.5 lbf ft)
–
Mount and tighten screw
2
.
Guideline
Screw, top
steering stem M8 20 Nm (14.8 lbf ft)
Loctite
®
243™
Finishing work
–
Check steering head bearing play. ( p. 53)
–
Remove the motorcycle from the lift stand. ( p. 46)
–
Mount the handlebar cushion.
11.13 Lubricating the steering head bearing
H02387-01
–
Remove the lower triple clamp. ( p. 50)
–
Install the lower triple clamp. ( p. 51)
Info
The steering head bearing is cleaned and lubricated in
the course of removal and installation.