Husqvarna F2101U0, Owner'S Manual

Page: 112 / 137

16 SERVICE WORK ON THE ENGINE
110
S03462-10
Main work
–
Remove gear oil drain plug
1
with magnet.
–
Remove gear oil drain plug
2
.
–
Remove filler plug
3
with the O-ring.
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug.
–
Clean the sealing surface on the engine.
–
Mount and tighten gear oil drain plug
1
with the magnet
and a new seal ring.
Guideline
Gear oil drain plug
with magnet M12x1.5 20 Nm (14.8 lbf ft)
–
Mount and tighten gear oil drain plug
2
with a new seal
ring.
Guideline
Gear oil drain plug M10x1 15 Nm (11.1 lbf ft)
–
Fill in gear oil.
Gear oil 0.8 l (0.8 qt.) Engine oil (15W/50)
(
p. 126)
–
Mount and tighten filler plug
3
with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check for leaks.
Finishing work
–
Check the gear oil level. ( p. 109)
16.3 Adding the gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Gear oil must only be topped up when the engine is cold.
Preparatory work
–
Park the motorcycle on a level surface.