English
– 21
OPERATING
•
Set the desired cutting depth by rotating the Depth knob.
The chosen cutting depth is now shown in the display in
small box called stop.
•
When the blade is lowered the current cutting depth will be
showing the difference between the reference point and
the diamond blade.
•
Lower the saw until the desired cutting depth is shown on
the display.
•
The saw will not lower to any depth greater than the stop
position set in the display. If a deeper cut is required, turn
the Blade depth knob to a new depth position. You can
also disengage the Blade depth stop by pushing the Blade
depth stop button to override the depth stop feature.
•
Disengage the blade depth stop by pushing the blade
depth stop button.
•
The Raise/Lower switch shall be in the down position
while trenching/cutting for maximum stability and
productivity.
Straight line sawing
While cutting, the blade is creating resistance to driving force
from rear wheels which will cause the machine to yaw in the
same direction as the blade is mounted on. This effect can be
counteracted by adjusting the angle of the rear axle using E-
track or manual axle adjustments.
E-track axle adjustment
•
On the control panel, push the E-track adjustment buttons
representing left and right rear axle adjustments. Press
several times for fine adjustments.
•
By pressing the E-track zero button on the control panel
the rear axle will return to predefined center angle.
•
Return to previous setting by once again pressing the E-
track zero button on the control panel.
•
The E-track gauge on the display will indicate the present
angle of the rear axle. The change is saved both if the
ignition is switched off or if the machine is without power.
•
Adjustments can be made both while sawing and not
sawing.
•
Visually confirm the axle movement and direction.
<1200 RPM
1
2
3
4
c
CURRENT:
STOP:
0
4
cm
cm
WORKING HOUR
V
8
10
12
16
14
V
100
40
60
80
120
c
STOP
4
cm
<1200 RPM
1
2
3
4
c
CURRENT:
STOP:
0
4
cm
cm
WORKING HOUR
V
8
10
12
16
14
V
100
40
60
80
120
c
8
10
12
16
14
V
100
40
60
80
120
c
<1200 RPM
1
2
3
4
c
CURRENT:
STOP:
0
4
cm
cm
WORKING HOUR
V
8
10
12
16
14
V
100
40
60
80
120
c
<1200 RPM
1
2
3
4
c
CURRENT:
STOP:
0
4
cm
cm
WORKING HOUR
V
8
10
12
16
14
V
100
40
60
80
120
c
<1200 RPM
1
2
3
4
c
CURRENT:
STOP:
0
4
cm
cm
WORKING HOUR
V
