20 –
English
OPERATING
Bolt on blade guards are secured by 4 screws.
Remove the blade guard
1
Disconnect the water hoses from the blade guard.
2
Unlock the front slider. Lift up and remove front slider.
3
Use a wrench to remove the 4 screws.
Blade depth stop
The cutting depth is set by adjusting the front support wheels
up/down.
For more information about maximum cutting depth for
different blade sizes, see section ”Blades”
Setting the cutting depth
•
Make sure that the machine is placed on a flat surface.
•
Activate the Blade depth stop on the control panel.
•
Lower the saw by pushing the Raise/lower switch on the
speed control lever downwards until the blade touches the
surface to be cut. This will be the reference point.
•
Then move the Raise/Lower switch back to neutral
position.
•
Press the Blade zero button on the control panel. The
current value in the display now reads 0.
•
Remove the blade.
•
The maximum cutting depth is set by adjusting the front
support up/down by loosening the 4 screws using a
wrench. Always tighten the screws after setting the depth.
NOTICE! Only saw as deep as the job specifications require
since deeper sawing can cause structural strength
problems.
<1200 RPM
c
CURRENT:
STOP:
0
4
cm
cm
WORKING HOUR
V
8
10
12
16
14
V
100
40
60
80
120
c
1
2
3
4
!
CAUTION! The touch should be smooth to
prevent damaging the blade. Use Saw
lowering speed control knob to slow down
the lowering speed.
<1200 RPM
1
2
3
4
c
CURRENT:
STOP:
0
0
cm
cm
WORKING HOUR
V
8
10
12
16
14
V
100
40
60
80
120
c
CURRENT:
0
cm
