Husqvarna CT 36, Operator'S Manual

Page: 42 / 652

Problem Cause Solution
The blade pitch system
does not operate cor-
rectly.
The blade pitch cable is broken or
incorrectly adjusted.
Let an approved service center repair the product.
1 or more of the blades do not move
correctly in the hub.
Remove the blades. Clean and lubricate all con-
tact surfaces.
The slot screw is missing at the rear
of the handle.
Let an approved service center repair the product.
The blade lift ring and/or the yoke
arm is broken or very worn.
Let an approved service center repair the product.
The blade pitch control on the han-
dlebar is defective.
Let an approved service center repair the product.
The belt wears too
quickly.
The pulley is incorrectly aligned. Let an approved service center repair the product.
The belt is damaged or of incorrect
type.
Replace the belt. Use only original Husqvarna
spare parts.
The clutch is defective. Let an approved service center repair the product.
The gearbox is defective. Let an approved service center repair the product.
There is an oil leak at
the top of the gearbox.
The gearbox seal is worn. Let an approved service center repair the product.
There is a leak in the engine. Let an approved service center repair the product.
There is too much oil in the gearbox. Let an approved service center repair the product.
There is an oil leak at
the gearbox main shaft
or the countershaft.
The shaft and/or the seal is worn. Let an approved service center repair the product.
The screws are loose. Let an approved service center repair the product.
Transportation, storage and disposal
Transportation
WARNING:
Be careful during
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
WARNING:
If an optional floating disc
is installed, remove it before transportation.
There is a risk that the floating disc falls off
and causes injury or damage.
Lift the product to move it shorter distances. For longer
distances, put the product on a transportation vehicle.
To fold the handle to transport position
CAUTION:
Decrease the blade pitch
fully before you fold the handle. If the blade
pitch is not decreased, the blade pitch cable
and the blade pitch control can become
damaged.
Note:
The handle cannot be folded on all models.
• Loosen the locking knob and fold the handle forward.
(Fig. 59)
To lift the product with lifting equipment
WARNING:
Make sure that the lifting
equipment has the correct dimension. The
type plate on the product shows the product
weight.
WARNING:
Do not lift a damaged
product. Make sure that the lifting bracket is
correctly installed and not damaged.
42 1452 - 002 - 20.05.2022