Husqvarna CR 125 2010, Manual, Page: 86 / 344

22
CLUTCH ADJUSTMENT
The clutch is adjusted by stretching the cable using the adju-
sting unit positioned on the handlebar.
As a rule it is sufficient to operate on the handlebar register to
restore the clearance due to the flexible transmission stretch.
The control lever must always have an empty stroke (C)
(3 mm) before starting clutch disengagement. To adjust this
clearance, act on register (2) after taking out rubber cap (1);
turn the register in the direction indicated by arrow A to redu-
ce the clearance (C); turn it in the direction indicated by arrow
B to increase the clearance.
1. Rubber cap
2.Adjusting screw
The adjustment can be also effected with tightener (1) set on
the right of the frame. Take care to tighten properly the lock
nut. If the clutch slips under load or drags in disengaged posi-
tion after play has been
adjusted, it must be taken apart for inspection. For this opera-
tion apply to a Dealer.
1. Adjusting screw
2. Locknut
3. Rubber cap
MUM1_WR125_GB_2010 15-06-2009 18:49 Pagina 22