Husqvarna BV 30, Operator'S Manual, Page: 12 / 20

Problem Cause Solution
The product does not stop when you
push the stop button.
The cable for the stop button is bro-
ken.
Examine the cable and replace it if it
is necessary.
The product starts but there is no vi-
bration.
The vibration damping unit on the vi-
bration shaft is damaged.
Replace the vibration damping unit
and the bearings on the vibration
shaft.
The vibrations in the product are not
correct.
The eccentric element is incorrectly
set.
Adjust the eccentric element. Adjust
50% if there is too much vibration.
Adjust 100% if the vibrations are not
sufficient.
The noise level is too high. The vibration bearings are damaged. Replace the vibration bearings.
The handle knobs are not sufficiently
tightened.
Tighten the handle knobs.
The vibrations are not equal along
the concrete surface.
The vibration frequency is too low. Increase the vibration frequency.
Incorrect vibration procedure. Operate the product correctly. Refer
to
To operate the product on page
10
.
The vibration in the handle is too
high.
The vibration damping units are
worn.
Replace the vibration damping units.
Refer to
Product overview on page 2
for the position of the vibration damp-
ing units.
Transportation, storage and disposal
Transportation
• Keep the handles folded during transportation.
• During transportation, keep the engine in a vertical
position to prevent fuel leakage.
• Safely attach the product during transportation to
prevent damage and accidents.
Storage
• Clean the product before storage.
• Keep the product in a dry and frost-free area.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
Disposal
• Obey the local recycling requirements and applicable
regulations.
• Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
• When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
12 1294 - 004 - 01.12.2021