Problem
Cause
Solution
The product makes
an irregular scratch
pattern.
The diamond tools are incorrectly attached or
attached at different heights on the grinding
discs.
Make sure that all diamond tools are installed
correctly and have the same height.
The diamond tools are of mixed types.
Make sure that all segments are the same
diamond grit and bond. If the diamond seg-
ments are rough, space out the rough dia-
mond segments equally. Operate the product
on an abrasive surface until all segments
have the same height.
The head locks are loose or missing.
Make sure that all head locks are in position
and tightened.
The resin tools are mixed or have unwanted
contamination.
Make sure that all resins are the same dia-
mond grit and bond and that there is no con-
tamination. To clean the resin tools, operate
them for a short time on a lightly abrasive
surface.
The grinding discs are worn or damaged.
Do a check on the grinding discs for broken
sections or too much movement.
There are sudden un-
wanted movements
in the product.
The grinding discs are worn or damaged.
Examine the grinding discs for damaged
parts and too much movement.
The diamond tools are incorrectly attached or
attached at different heights on the grinding
discs.
Make sure that all diamond tools are installed
correctly and that all have the same height.
The internal circuit
breaker releases.
BG 250: Too high a load or not sufficient
power supply.
Do a check of the power supply.
Decrease the grinding pressure, increase the
number of diamond tools or increase the
bond hardness.
The product stops
again when you start
it.
Speak to an approved service center.
Transportation, storage and disposal
Transportation
WARNING:
Be careful during
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
The wheels let you move the product shorter distances.
For longer distances, lift the product to move it or put the
product on a vehicle.
CAUTION:
Do not tow the product
behind a vehicle.
• Be very careful when you move the product
manually or on surfaces with a slope. Small slopes
can result in a fast movement that is not possible to
brake by hand.
• Safety the product during transportation. Make sure
that it cannot move.
• Put some type of protection on the product
during transportation. The protection keeps natural
elements such as rain and snow away from the
product.
• Always use the lifting eye on the product when you
lift the product.
• Do not lift the product by the handlebar, motor,
chassis or other parts.
• Transportation is best done on a pallet.
• Always lift the product with a lift or forklift.
54
1802 - 002 - 13.04.2022
Summary of Contents for BG 250
Page 119: ...1802 002 13 04 2022 119 ...