• Make sure that a leak cannot occur when you move
the product or fuel container.
• Do not put the product or a fuel container where
there is an open flame, spark or pilot light. Make
sure that the storage area does not contain an open
flame.
• Only use approved containers when you move the
fuel or put the fuel into storage.
• Empty the fuel tank before long-term storage. Obey
the local law on where to dispose fuel.
• Clean the product before long-term storage.
• Remove the spark plug cap before you put the
product into storage to make sure that the engine
does not start accidentally.
Safety instructions for maintenance
WARNING:
Read the warning
instructions that follow before you use the
product.
• Your warranty may not cover damage or liability
caused by the use of non-authorized accessories or
replacement parts.
• The inside of the muffler contains chemicals that
may be carcinogenic. Avoid contact with these
elements in the event of a damaged muffler.
• Stop the engine before assembling or dismantling
accessories or other parts.
• Check that the thick round pin in the clamp is
inserted in the strap. If it is inserted incorrectly it may
lead to personal injury.
Assembly
Introduction
WARNING:
Read and understand the
safety chapter before you assemble the
product.
To assemble the tube and handle on
the product :580BTS Mark III
1. Attach the flexible hose (A) to the pipe angle and the
control pipe (B) with the clamps (C), (D).
B
D
A
C
Note:
Lubricate the control pipe and the flexible
hose to make them more easy to assemble.
2. Attach the handle (E) to the control pipe and put the
knob through the handle.
E
3. Tighten the knob.
4. Attach the cable to the flexible hose with the cable
clamp.
10
1667 - 002 - 19.04.2021
Summary of Contents for 580BFS Mark III
Page 63: ...1667 002 19 04 2021 63 ...
