Husqvarna 525HE3, Operator'S Manual

Page: 10 / 80

To install the handle
• Install the handle with the 2 screws.
To install the impact guard (optional)
• Install the impact guard with the 3 screws.
To adjust the harness (525HE4)
Always use the harness when you operate the
product. The harness gives maximum control
during operation of the product. The harness
decreases the risk of tiredness in your body.
1. Put on the harness.
2. Attach the product to the harness support
hook.
3. Adjust the length of the harness until the
support hook is level with your hip.
Operation
Introduction
WARNING:
Before you operate
the product, you must read and
understand the safety chapter.
To do before you operate the product
• Examine the work area and remove loose
objects.
• Do a check of the cutting unit. Refer to
To
examine the blades on page 19
.
• Make sure that the safety devices of the
product operate correctly. Do not use the
product without all safety devices installed
correctly.
• Make sure that all screws and nuts are
tight.
• Make sure that all covers are attached
correctly and not damaged before you start
the product.
• Make sure that the cutting unit stops when
the engine is at idle speed.
Fuel
This product has a two-stroke engine.
CAUTION:
Incorrect type of fuel
can result in engine damage. Use a
mixture of gasoline and two-stroke
oil.
10 1173 - 001 -