• For higher air speed, attach the high speed
nozzle to the lower tube.
To attach the scraper tool
The scraper tool can be used to loosen leaves
and other unwanted material for easier cleaning.
• Attach the scraper tool to the lower tube until
the tab (A) goes into the hole (B). Make sure
that the scraper tool and the tube are locked
together.
B
A
To install the battery charger on the
wall
CAUTION:
Do not use an electric
screwdriver to install the battery
charger to the wall. An electric
screwdriver can cause damage to the
battery charger.
1. Install the battery charger on the wall with
the 2 screws (B). Use wall plugs (A) if it is
necessary.
D
A
B
B
C
2. Install the 2 screw hole plugs (C).
3. Connect the power cord to the battery charger
and a mains socket.
Operation
Introduction
WARNING:
Read and understand
the safety chapter before you use the
product.
To do a function check before you use
the product
1. Do a check of the air inlet for dirt and cracks.
Use a brush and clean off grass and leaves
from the product.
2. Make sure that the product works correctly.
3. Do a check of all nuts and screws and make
sure that they are tight.
To connect the battery charger
WARNING:
Only use the battery
charger in ambient temperatures
between 5°C/41°F and 40°C/104°F.
1. Connect the battery charger to the voltage
and frequency that is specified on the rating
plate.
2. Put the plug in a grounded power outlet. The
LED on the battery charger flashes red 1 time
and green 1 time.
To charge the battery
CAUTION:
Make sure that the
battery, the battery charger and the
terminals on the battery are clean and
1776 - 002 - 09.03.2022
11
Summary of Contents for 350iB
Page 55: ...1776 002 09 03 2022 55 ...
