Husqvarna 335RJX series, Operator'S Manual

Page: 12 / 36

ASSEMBLY
12 – English
Fitting a blade guard, grass blade
and grass cutter
• Hook the blade guard/combination guard (A) onto the
fitting on the shaft and secure with the bolt.
CAUTION!
Ensure that the guard extension is removed.
Use the recommended blade guard. See the Technical
data section.
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Place the blade (D), support cup (E) and support flange
(F) on the output shaft.
• Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the
tool kit. Hold the shaft of the spanner as close to the
blade guard as possible. To tighten the nut, turn the
spanner in the opposite direction to the direction of
rotation (Caution! left-hand thread).
Fitting other guards and cutting
attachments
• Fit the trimmer guard/combination guard (A) intended for
use with the trimmer head/plastic blades.
CAUTION!
Ensure that the guard extension is fitted.
Hang the trimmer guard/combination guard (A) on the
two hooks on the plate holder (M). Bend the guard
around the shaft and tighten it with the bolt (L) on the
opposite side of the shaft. Use the locking pin (C). Place
the locking pin in the groove on the screw head and
tighten. See diagram.
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
• To dismantle, follow the instructions in the reverse order.
G
F
D
B
C
A
E
A
A
L
C
M
B
A
M
L
C
H
H
H