Husqvarna 333RB Mark II, Workshop Manual, Page: 40 / 48

4. Put the spring (C) on the throttle lock (D) and put it
in the correct position on the handle half. Put the
throttle trigger (A) on the handle, make sure the end
of the spring (B) is in the correct position in the
handle. Make sure that the black cable (G), the red
cable (F), the stop switch (H) and the throttle wire
(E) are attached as shown in the illustration.
E
G
F
C
H
A
B
D
5. Put the shaft in the left handle half and attach the
right half with the screws and the nuts. Make sure to
use the correct torque, see Servicing data on page
6.
.
7.14 Gearbox
7.14.1 To remove the gearbox
1. Put a rod through the hole (B) to lock the axle.
J
C
Y
A
G
F
E
D
B
H
I
2. Remove the trimmer head (A).
3. Remove the support flange (Y).
4. Remove the protective plate (C).
5. Remove the screw (D), the screws (E) and the
bracket (F).
6. Remove the screw (G) and the bracket (H).
7. Remove the screw (I) and pull out the gearbox (J).
40 - Repair instructions 1291 - 001 - 27.09.2019