Husqvarna 331RB, Workshop Manual

Page: 12 / 48

7. Centrifugal clutch
8. Flywheel
9. Cylinder and piston
10. Crankcase and crankshaft
11. Fuel tank
12. Frame and harness
13. Handle
14. Gearbox
7.2 To clean and examine the product parts
• Clean and examine all parts fully. You find more
instructions in the chapter for each part if special
tools or procedures are necessary.
• Replace damaged or defective parts.
• Always use original spare parts.
7.3 Starter
7.3.1 To disassemble the starter
WARNING: Use protective glasses to prevent
injury to the eyes if the recoil spring ejects.
1. Remove the 4 screws and pull out the starter and
the gasket.
2. Pull out the starter rope approximately 30 cm.
3. Put your thumb on the starter pulley.
4. Put the starter rope in the groove in the starter
pulley.
5. Let the starter pulley rotate rearward until the spring
tension stops.
WARNING: Be careful, the recoil spring can
cause injury to your thumb when the starter
pulley rotates rearward.
6. Remove the screw (A), the washer (B), the pulley
(C) and the torsion spring (D).
C
B
D
E
F
G
A
7. Remove the starter pulley (E) to get access to the
recoil spring (F).
WARNING: Be very careful when you
remove the starter pulley. The recoil spring
can eject and cause injury to you.
8. Carefully remove the recoil spring (F) from the
starter housing (G).
12 - Repair instructions 1281 - 001 -