Husqvarna 320iL, Operator'S Manual, Page: 14 / 72

To disassemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling.
2. Push and hold the lock button (A). Pull the
shafts apart.
A
B
To attach the cutting attachment guard
• Attach the cutting attachment guard (A) to the
shaft (C) with the screws (B).
A
B
C
To install the battery charger on the
wall
CAUTION:
Do not use an electric
screwdriver to install the battery
charger to the wall. An electric
screwdriver can cause damage to the
battery charger.
1. Install the battery charger on the wall with
the 2 screws (B). Use wall plugs (A) if it is
necessary.
D
A
B
B
C
2. Install the 2 screw hole plugs (C).
3. Connect the power cord to the battery charger
and a mains socket.
Operation
Introduction
WARNING:
Read and understand
the safety chapter before you use the
product.
Before you operate the product
• Examine the work area to make sure that you
know the type of terrain. Examine the slope of
the ground and if there are obstacles such as
stones, branches and ditches.
• Do a general inspection of the product.
14 1511 - 006 - 11.01.2022