SAVE THESE
INSTRUCTIONS
Assembly
Introduction
This section describes how to assemble and
adjust the product.
WARNING:
Before you assemble
the product, read the safety chapter
and the assembly instructions.
To assemble the loop handle
1. Attach the loop handle onto the shaft between
the arrows.
2. Move the spacer into the slot of the loop
handle.
3. Install the screw and the knob. Do not tighten
too much.
4. Adjust the loop handle to an applicable
position.
5. Tighten the knob.
To assemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling.
2. Push in the lock button (A) and push the shaft
into the shaft coupling until the lock button
sets in the hole (B).
A
B
Note:
If you cannot push the shaft fully into
the shaft coupling, turn shaft to make the
internal drive shafts connect.
3. Tighten the knob fully, before you operate the
product.
1511 - 006 - 11.01.2022
13
Summary of Contents for 320iL
Page 71: ...1511 006 11 01 2022 71 ...