Husqvarna 225i, Operator'S Manual

Page: 19 / 120

To stop the product
1. Push the start/stop button until the green LED light
goes off.
2. Push the battery release buttons and remove the
battery from the battery holder to prevent accidental
start.
Pull stroke and push stroke
You can cut through wood with the product in 2 different
positions.
• To cut on the pull stroke is when you cut with the
bottom of the guide bar. The saw chain pulls through
the tree when you cut. In this position you have
better control of the product and the position of the
kickback zone.
• To cut on the push stroke is when you cut with the
top of the guide bar. The saw chain pushes the
product in the direction of the operator.
WARNING:
If the saw chain is
caught in the trunk, the product can be
pushed at you. Hold the product tightly
and make sure that the kickback zone
of the guide bar does not touch the tree
and causes a kickback.
To use the cutting technique
WARNING:
Use full power when you
cut and decrease the speed to idle speed
after each cut.
CAUTION:
Do not let the motor operate
for too long without load. This can cause
damage to the motor.
1. Put the trunk on a saw horse or runners.
WARNING:
Do not cut trunks in a
pile. That increases the risk of kickback
and can cause serious injury or death.
1860 - 001 - 23.09.2022 19