Husqvarna 2014 FC 450 EU, Owner'S Manual

Page: 37 / 99

11 SERVICE WORK ON THE CHASSIS
35
11.9 Removing the fork protector
x
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 32)
–
Remove the front wheel.
x
( p. 64)
–
Remove the fork legs.
x
( p. 33)
B00306-10
Main work
–
Remove screws 1 on the left fork leg. Lift off the fork protector.
–
Remove the screws on the right fork leg. Lift off the fork protector.
11.10 Installing the fork protector
x
B00306-10
Main work
–
Position the fork protector on the left fork leg. Mount and tighten screws
1
.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Position the fork protector on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Finishing work
–
Install the fork legs.
x
( p. 34)
–
Install the front wheel.
x
( p. 64)
11.11 Removing the lower triple clamp
x
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 32)
–
Remove the front wheel. x ( p. 64)
–
Remove the fork legs.
x
( p. 33)
–
Remove the start number plate. ( p. 38)
–
Remove the front fender. ( p. 39)
B01864-10
Main work
–
Take off cable holder
1
in front of the left radiator.
–
Remove screw
2
.
–
Remove screw 3 .
–
Take off the top triple clamp with the handlebar and set it aside.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
B01865-10
–
Remove O-ring
4
. Remove protective ring
5
.
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.