HUSABERG FE 450 AUS, Repair Manual

Page: 42 / 285

04/SHOCK ABSORBER, SWINGARM
40
200812-10
–
Measure the diameter of the piston rod.
Piston rod
Diameter
≥
17.95 mm (
≥
0.7067 in)
» If the specified value was not attained:
–
Replace the piston rod.
–
Measure the run-out of the piston rod.
Piston rod
Run-out
≤
0.02 mm (
≤
0.0008 in)
» If the measured value is greater than the specified value:
–
Replace the piston rod.
–
Check the piston rod for damage and wear.
» If there is damage or wear:
–
Replace the piston rod.
200813-10
–
Check the piston rings for damage and wear.
» If damage or a bronze-colored surface is visible:
–
Replace the piston rings.
7.18
Disassembling the rebound adjuster
–
Disassemble the piston rod. ( p. 37)
200805-10
–
Warm up the piston rod in the area of the rebound damping valve seat.
Guideline
80 °C (176 °F)
–
Remove rebound damping valve seat

.
200806-10
–
Remove screwsleeve

.
–
Remove adjusting screw

.
Info
Do not lose balls

and spring.
200807-10
–
Remove rubber plug

.
–
From the opposite side, press rebound needle

out of the piston rod.