HUSABERG FE 450 AUS, Repair Manual

Page: 137 / 285

30/ENGINE - WORK ON THE INDIVIDUAL PARTS
135
–
Change the solid gear or the countershaft.
–
Check stop disks

for damage and wear.
» If there is damage or wear:
–
Change the stop disks.
–
Use new lock rings

with every repair.
19.47
Checking the electric starter mode
0 0 3 3
0 0 6 6
0 0 5 5
0 0 2 2
0 0 1 1
0 0 4 4
300606-01
–
Check the gear mesh and bearing of starter idler gear

for damage and wear.
» If there is damage or wear:
–
Change the starter idler gear.
–
Check the gear mesh and bearing of torque limiter

for damage and wear.
» If there is damage or wear:
–
Change the torque limiter.
–
Check the gear mesh and bearing of free wheel gear

for damage and wear.
» If there is damage or wear:
–
Change the free wheel gear or bearing.
–
Check free wheel

for damage and wear when it is disassembled.
» If there is damage or wear:
–
Change the free wheel.
–
Checking the gear mesh of starter motor

for damage and wear
» If there is damage or wear:
–
Change the starter motor.
–
Change the O-ring

of the starter motor.
–
Connect the negative cable of a 12 volt power supply to the housing of the starter
motor. Briefly connect the positive cable of the power supply with the connector of
the starter motor.
» If the starter motor does not turn when the circuit is closed:
–
Change the starter motor.
19.48
Removing the free wheel
300454-10
–
Press expansion ring

together with suitable pliers and take off.
300456-10
–
Take out free wheel

from the primary pinion.