Hurco winmax, Programming Manual, Page: 46 / 254

1 - 26 Overview
704-0115-307
WinMax Lathe NC Programming
Program Execution Menu
Program Execution menu allows selection of the part program to be processed for
graphics and for execution. This menu can be accessed by twice pressing More

(first
from the Basic Programming menu and then from the Renumbering and Tagging menu).
Figure 1–12. ISNC Program Execution Menu
The menu contains the following softkeys:
• Set Start Marker—indicates the block that the system should use to start
program execution when running and verifying the program. A letter S is
inserted to the left of the block. All blocks previous to the Start block are
grayed out.
• Set End Marker—indicates the block that system should use to end program
verification and execution. A letter E is inserted to the left of the block. All
blocks following the End block are grayed out.
• Reset Start/End Markers—restores start and end markers to their
defaults. The defaults are at the beginning and end of the program.
• More

—invokes NC Editor Settings menu.
• Exit Editor—exits the NC Editor and moves to the Input screen. Select Part
Programming to return to the NC Editor screen.
If the Start and End markers overlap, the dollar ($) sign is displayed
to the left of the line.