1 - 10 Overview
704-0115-307
WinMax Lathe NC Programming
Default M and G Codes
Upon power up, control reset, initial entry into the NC Editor, or after erasing a program,
the system presets these M codes as defaults:
M05
Spindle Off
M09
Both Coolant Systems Off
The system also presets certain G codes as the default active codes. The default G codes
are highlighted in the BNC G Code Table, on page 2 - 3 and the ISNC G Code Table, on
The system uses the units specified when the NC Editor is selected, not the G codes, for
graphics display and running the part program.
Navigation
To move the cursor from a block to the beginning of the next block, press the down arrow
(
). Use the right/advance arrow (
) and the left/back arrow (
) to move the cursor
within a block. Use the Enter key to move the cursor between words and blocks.
To move to the beginning of the current block, press the Home key or the up arrow (
). If
the cursor is already at the beginning of the block, pressing the up arrow moves the
cursor to the beginning of the last word in the previous block.
To move from a word to the beginning of the next word, press the Enter key. If the cursor
is at the end of the current block when the Enter key is pressed, the editor automatically
presents the next legal address character. To move from one character to the next, press
the right arrow. If the cursor is at the end of the current block, the cursor wraps around
to the beginning of the block.
To move from one character to the preceding character, press the left arrow. If the cursor
is at the start of the current block, it wraps around to the end of the current block.
Delete characters or words from a block using these methods:
•
To delete numeric data, position the cursor on the number and press the
Delete key.
•
To erase the entire word, position the cursor on the address character and
then press the left arrow or the Delete key. The entire word is removed since
numeric data is not allowed in an NC program without an address character
to introduce it.
Summary of Contents for winmax
