Hurco winmax, Programming Manual, Page: 29 / 254

WinMax Lathe NC Programming
704-0115-307
Overview
1-9
Block Data Formats
The table below shows the format (ranges) for the different types of blocks of part
program code.
Table 1–3. Block Data Formats
Entry Description Format (range)
G G Code 5 (0-65535)
M M (Miscellaneous) Code 5 (0-65535)
S Spindle Speed (rpm) and (css) 9 (0 - 2 x 10
9
) (no practical limit)
T Tool Code + Offset
T00 cancels tool offsets 0 (0-999999999)
N N Numbers 9 (0-999999999)
F G94 FPM Mode
G95 FPR Mode Refer to BNC G20 - Inch Mode (default)
and G21 - Millimeter Mode or ISNC G20 -
Inch Mode (default) and G21 - Millimeter
Mode for these formats.
F Dwell in G94 fpm mode
Dwell in G95 fpr mode 3.4 seconds (0.0001 - 999.9999)
3.4 revs (0.0001 - 999.9999)
Where decimals are included in the format, the number on the left of
the decimal (3) represents the number of places to the left and the
number on the right (4) of the decimal represents the number of
places to the right of the decimal.
3.4 = nnn.nnnn