Hurco AB6, Installation Manual

Page: 89 / 165

Installation Manual
2-50 Revision E Hurco
Carriage Arrestor Bars
Use carriage arrestor bars for safety devices. They consist of two plates
that clamp to each gauge frame and provide a forward positive hard stop
for the carriage. Place each arrestor bar at a point that prevents the gauging
surface from interfering with the forming tools. Set them in the correct
position each time after a tooling change and/or re-referencing the gauge
bar.
Refer to the figure below for the S6 or S8 gauge.
Figure 2-39. Carriage Arrestor Bar on S6 or one S8 Gauge