Installation Manual
2-44
Revision E
Hurco
LP11, LP21, and LP22 Gauges
Install vertical supports to LP11 and LP22 gauge bars as follows:
1.
Remove the two (2) 3/8"–16
×
1 SHCS from the bottom of
the support assembly.
2.
Insert the vertical supports into the corresponding sockets on
the outside of the gauge carriage. Also, keep the horizontal
bar on the outside of the supports.
3.
Re-install the two screws and tighten.
Here is a vertical support for LP11, LP21, or LP22 gauges:
Figure 2-34. LP11, LP21, and LP22 Gauge Bar and Vertical Supports
Where can we go from here?
Proceed to the “LP11 and LP22 Gauge Bar” section of this chapter.
Summary of Contents for AB6
Page 3: ...iv Revision E Hurco...
Page 5: ...vi Revision E Hurco...
Page 13: ...Installation Manual xiv Revision E Hurco...
