Getting started instructions for Access DH2 Prober
21-2627 Rev A Version 1.4
1
Getting Started Instructions for the Access DH2 Probers
** Read the Access DH2 CAUTION SHEET before proceeding with these
instructions **
Tools Needed
•
½’ wrench or socket
•
Philips Screw driver
Monitor Arm Setup
1.
Connect the two CABLE, USB EXTENSION 3M (98-0531) on the back of the computer.
2.
Connect the CABLE DVI 10FT MALE-MALE (98-0704) to the add-in Graphics card on the
back of the computer.
3.
Connect the POWER CORD C14 C15 6FT 14 AWG (98-0742) to the back of the PDU.
4.
Feed the other ends of the cables out the access hole at the upper from of the Access DH
on the side where the ARM, MONITOR/KEYBOARD/MOUSE (98-0597) will be
mounted.
5.
Remove the bolts holding the straps on the sides of the Access DH.
6.
Secure the arm mount to the side of the Prober using provided bolts to the existing
threaded holes. The arm mount can be secured to either side of the Prober.
7.
Assemble arm as per instructions included with kit and insert into arm mount.
8.
Mount Keyboard holder and monitor stand with 4 flathead screws.