8
HP monitors will require all four retained screws. Planar monitors will require two of
the supplied screws and two 75-659-2 screws (supplied in accessories kit). If needed,
instructions to remove the planar stand are included with the monitor.
7. Align the monitor with the four holes located on the display support and screw in place with the retained
screws.
Figure 13
A magnetic tip screwdriver is recommended for this step. It may be necessary to
remove the adjustment knobs and flip over the mount plate to more easily secure the
monitor.
8. Cut the tie strap holding the air hose and LCD power cable located on the back side of the balancer.
The power cable (in the base of the balancer) has two IEC C13 female connectors. The
shorter cable supplies power to the power supply. The longer cable supplies power to
the LCD monitor.
Figure 14
